Entry/Exit

The Default button will have additional options and values that can be changed.
Entry Inc – this value is the distance that the toolpath will rapid to above the start point of the pass before going into feed motion.
Exit Inc – this is the distance the tool will travel in a feedrate mode when leaving the steel before it goes into a rapid movement.

Window Parameters will let the system know how the user wants the tool to make contact with the window used, there are three options.

Center – this will let the system know that the user wants the center of the tool to be on the edge of the window.

Inside – will let the system know if the user wants the tool to stay completely inside the window.

Outside – will let the system know if the user wants the tool to go just to the outside on the window.