Drill


Dwell
Enter the number of seconds for the tool to dwell.

Auto Depth
With this option checked select the starting circle and the final ending circle. There is an option for the system to only go a % of the depth. Insert the percentage of the depth required. With the Auto Depth unchecked the options change. Enter what circle to start from and how deep to go from that circle under Depth of Cut.

Start Circle/Offset
Is used to tell the system which circle to start from and give it offset to start higher or lower than the start circle. Enter a positive number the tool will start higher than the start circle. Enter a negative number and the tool will start below the start circle.

Ending Circle/Offset
Is used to tell the system which circle to stop at and give it offset to start higher or lower than the start circle. Enter a positive number the tool will start higher than the start circle. Enter a negative number and the tool will start below the start circle.