Verification Tab

Here you can set which programs are checked for violations, every type of program that has a check mark next to it will be checked for violations.

With these boxes checked you can also violation check the output ISO file

Here are the parameters for the collision check, you can have it on or off, or set it to check to the head of the machine or not.
Head Clearance (mm) – here you will set the desired clearance distance you want between the head of the machine and the part.
Collision Test – here you can have it check all moves or the rapids moves by themselves, or the feed moves by themselves.
Active Head- Displays the active Head when simulating.
Decimate Head-this create a lightweight Head for faster collision detection
Drill Collision Length-this is an option for a future drill function
Sample Distance (mm) -here you will set the desired clearance distance you want between the holder and the part

Z Security Undercut Protection-this option makes sure that retracts are extended when in an undercut condition
.Post Retract Correction
Intersect Element-this is the amount to raise the rapid retract above a detected interference while posting multiple files.