====== ATC ======

{{::atc.png?nolink|}}

In this section it is asking for information on the tool changer of the machine.

**Number of Pockets** – Fill in the number of pots on the tool changer of the machine.

**Starting Pocket Number** – Enter the pot number for the system to start the ATC in the Tool Database.\\

**Reversed Tools** – Reserve a section of the tools in the ATC for certain tools that will never change. For example, reserve tools 1 to 5 and only use them for tools that will never change.\\

**Default Tool Length Offset** – Set a tool length to use all the time or to leave an extra .05 on the top of every job. \\

**If Too Many Tools** – if there are more tools than the ATC can hold this will give two options, **break program** and use **virtual ATC**. Both of these options will need to be setup by the Mach2D personnel.\\

**File** – The ATC per Model function allows the user to save the **ATC** with each session and when a new session is started it will load a new ATC. The Global ATC function will save the ACT to a file that will be loaded every time a new session is started; therefore, the ATC will never change unless changed by the user.\\

**Fagor Offset**- Allows the Fagor offset to be used W/Fagor control- Contact Mach2D agent.