====== Countersink ======

{{::dmcountersink1.png?nolink|}}

This program allows the user to use a counter sink tool to counter sink the holes.\\
**Chamfer Size**\\
 Input the desired chamfer size required.\\
**Depth of Cut**\\
The system will automatically calculate what depth of cut is required for the Chamfer Size.\\
**Dwell**\\
Input the number of seconds to dwell.\\
**Start Circle/Offset**\\
 Is used to tell the system which circle to start from and give it offset to start higher or lower than the start circle. Enter a positive number the tool will start higher than the start circle.  Enter a negative number and the tool will start below the start circle.\\
Draw up the proper counter sink tool to get the results needed.\\

{{::dmcountersink2.png?nolink|}}