====== Center ======
This program is typically used for center drilling.  There are three fields that need to be completed.

{{::centerdrill1.png?nolink|}} {{::centerdrill2.png?nolink|}}\\
**Depth of Cut**\\
This will determine the depth the tool will go.\\
**Dwell**\\
Enter the number of seconds for the tool to dwell.\\
**Start Circle/Offset**\\
Is used to tell the system which circle to start from and give it offset to start higher or lower than the start circle. Enter a positive number and the tool will start higher than the start circle. Enter a negative number and the tool will start below the start circle.\\