====== C/Bore ======

This program is typically used to counter bore holes. These are the fields to be completed.\\
{{::dmcbore1.png?nolink|}}{{::dmcbore2.png?nolink|}}\\
**Dwell**\\
Enter the number of seconds for the tool to dwell.\\
**Peck Depth**\\
Enter the amount to drill per peck until the specified depth is reached.\\
**Auto Depth**\\
With this option checked select the starting circle and the final ending circle.  There is an option for the system to only go a % of the depth. Enter the percentage of the depth required. With Auto Depth unchecked the options change. Enter what circle to start from and how deep to   go from that circle under Depth of Cut.\\
**Start Circle/Offset**\\
Is used to tell the system which circle to start from and give it offset to start higher or lower than the start circle. Enter a positive number the tool will start higher than the start circle.  Enter a negative number and the tool will start below the start circle.\\
**Ending Circle/Offset**\\
Is used to tell the system which circle to stop at and give it offset to start higher or lower than the start circle. Enter a positive number the tool will start higher than the start circle.  Enter a negative number and the tool will start below the start circle.\\

{{::dmcbore3.png?nolink|}}\\