====== Chamfer ======
{{:cadtabmanipulate38.png?nolink|}}\\
This option will allow the user to put a chamfer on selected corners.\\
The **Selection** window will open and the user will select the two curves that intersect where the chamfer is needed and select **OK** to confirm.  The **Chamfer** window will open and the following information will need to be entered to complete the chamfer.\\
{{:cadtabmanipulate39.png?nolink|}}{{:cadtabmanipulate40.png?nolink|}}\\
**Angle** – this value is the angle of the chamfer.\\
**Distance** – this is the length of the chamfer needed.\\
Once the values are entered select **OK**.\\
Before and after results are shown below.\\

Before{{:cadtabmanipulate41.png?nolink|}}{{:cadtabmanipulate42.png?nolink|}}After\\