====== Entry/Exit ======

{{::ribcutgeo12.png?nolink|}}For the Entry/Exit Options there are three option to choose from to help with a more efficient toolpath.\\
{{::ribcutgeo13.png?nolink|}}None – this option will not retract to go from one level to the next.\\

{{::ribcutgeo14.png?nolink|}}\\

{{::ribcutgeo15.png?nolink|}}\\
**Incremental** – this option will have the tool lift before it goes to the next level.\\
**Plunge Dist** – is the amount the tool will retract in between level.\\
**Plunge Angle** – this value will tell the system what angle to approach each level.\\

{{::ribcutgeo16.png?nolink|}}\\
The following was used for the example to the left.\\
Plunge Dist - .1\\
Plunge Angle – 0.000\\

{{::ribcutgeo17.png?nolink|}}\\
The following was used for the example to the left.\\
Plunge Dist - .1\\
Plunge Angle – 75.000\\

{{::ribcutgeo18.png?nolink|}}\\
**Full Ramp** – this option will ramp the tool the full length of each level so the tool does not plunge.\\
{{::ribcutgeo19.png?nolink|}}\\

{{::ribcutgeo20.png?nolink|}}\\
The Default button will have additional options and values that can be changed.\\
**Entry Inc** – this value is the distance that the toolpath will rapid to above the start point of the pass before going into feed motion.\\
**Exit Inc** – the distance the program stays in feed mode when it lifts from the steel.\\