====== Entry/Exit ======
{{::entryexit_optionsflat1.png?nolink|}}\\
The Default button will have additional options and values that can be changed.\\
**Milling Tol** – determines the accuracy of the toolpath.\\
**Entry Inc** – this value is the distance that the toolpath will rapid to above the start point of the pass before going into feed motion.\\
**Exit Inc** – the distance the program stays in feed mode when it lifts from the steel. \\

Window Parameters will let the system know how the user wants the tool to make contact with the window used, there are three options.\\

{{::entryexit_optionsflat2.png?nolink|}}\\
**Center** – this will let the system know that the user wants the center of the tool to be on the edge of the window.\\

{{::entryexit_optionsflat3.png?nolink|}}\\
**Inside** – will let the system know if the user wants the tool be stay completely inside the window.\\

{{::entryexit_optionsflat4.png?nolink|}}\\
**Outside** – will let the system know if the user wants the tool to go just to the outside on the window\\